SP®FLOOR COLOR COATING FOR EPOXY FLOOR

- Good adhesion on metal and concrete surfaces.

- Good resistance against abrasion, high physical impact, chemical.  Good color stability and ani-moss.

- Extremely well heat resistance. Paint can be used for heated surfaces up to 100^oC (non-continuous).

- The painting surface must be clean, dry and free from oil, grease, other impurities and no chalking.
- Please contact manufacturer for more info.

- Stir the base part (part A) well with a hand tool or stirrer. Slowly pour the curing portion (part B) into the container has part A at a rate of 4 part A and 1 part B. Stir for about 3-5 minutes.

- Use SP®TN300, 305 solvent only when required (Maximum rate of 3% by mass of A & B mixtures).

- Mixing should not be left exceed 5 hours at 23^oC.

- The minimum applied surface temperature reaches 10^oC and is 5^oC higher than the dew point of the air. Construction environment humidity ≤ 85%.

- It is not recommended to apply in the rain, early morning or late afternoon when there is high humidity to prevent the paint from fading.