SP ® ZINP - 101, 701 EPOXY ZINC PHOSPHATE PRIMING PAINT

• High adhesion.
• Durable with petroleum, sea water, fresh water, chemicals, climate.
• High heat resistance. This paint can be used for heated surfaces up to 110⁰C.

The surface should be dry, clean, free of any other impurities. The surface should be assessed and treated

in accordance with ISO 8504.

For surface of new untreated steel: Grade of cleanliness is Sa 2.5 (ISO 8501-1: 1998). Mechanical cleaning up to the minimum standard of St2 (ISO 8501-1: 1998) may be acceptable depending on the intended use.

For temporary primer-coated steel surfaces: The appropriate temporary primer coat surfaces should be

clean, dry, free from contamination and free of any foreign matter, such as oil and grease.

For surface had old painting layer: The appropriate primer must be dry, clean and free from decomposition.

• Stir the base part (part A) with a stirrer. Slowly pour the curing portion (part B) into the container has part
• A at a rate of 10 parts A and 1 part B. Stir evenly for 3 minutes until the mixture is homogeneous.
• Use only the solvent when recommended (maximum 5% of weight of A & B mix).

Mixing should not exceed 6 hours at 23⁰C.